Sony ipela nsr series Benutzerhandbuch

182

Miscellaneous

Example: For the NSR-100/50

When it does, proceed as follows.
1 Click [Shutdown] and turn off the NSR.
2 Referring to “Cannot access the hard drive.”, verify whether the NSR hard 

disks are correctly connected.

3 Restart the NSR and verify whether it starts.
4 If the same screen as above appears again, insert the supplied NSR Series 

Recovery CD into the CD and DVD drive, and then turn off the NSR. In 
this state, restart the NSR, and select “2. Check file System” when the 
following screen appears.

Checking the file system may take several hours.

5 When the check is finished, select “7. Shutdown the system”, and turn off 

the recorder.
In addition, do not use any menu option other than “2. Check file system” 
or “7. Shutdown the system”, as the others are for maintenance purposes.

6 Restart the NSR and immediately eject the NSR Series Recovery CD. Then 

verify whether the NSR starts correctly.

• Verify whether the NSR is on.
• Verify whether the power cord is correctly connected.
• Verify whether the monitor cable is correctly connected. Confirm that the 

monitor is connected to VGA connector 1.

• If you configure the wrong monitor resolution, the “Out of range” message 

may appear when the monitor resolution is too low compared to the monitor 
output. Press CTRL+ALT+MINUS SIGN as many times as necessary to 
lower the resolution of the output video. When the output image resolution 
reaches the resolution of the monitor, the image appears. Subsequently,