Sony pdw-v1 Benutzerhandbuch

14

 Before Using the Unit

This unit is shipped with the line mode still unset. 
Therefore you need to set the line mode before using the 
unit. (The unit cannot be used unless the line mode is set.)
Once it is set, the line mode is retained even when the unit 
is powered off.

Use the following procedure to set the line mode.

Power the unit on.

“Select ----” appears in the time data display.

With the SHUTTLE button held down, rotate the jog 
dial.

When you rotate the jog dial in the forward direction, 
the “----” part of the display changes in the sequence 
525U > 525J > 625. When you rotate it in the reverse 
direction, the display changes in the sequence 625 > 
525J > 525U.

When the desired setting appears, release the 
SHUTTLE button.

“Push SET !!” appears.

To redo the selection
Repeat step 2.

Press the SET button.

“Turn OFF !!” appears.

Power the unit off, and then power it on again.

The selected line mode becomes available for use.

You can change the setting made with this procedure 
by using basic menu item 013 “525/625 SYSTEM 
SELECT.” See 7-2-2 “Basic Menu Operations” (page 
69) for more information about how to make basic 
menu settings.

The line mode is not set, or is cleared, in the following 
situations. Reset the line mode.
• The unit is powered off before performing step 4 in the 

previous procedure.

• The “RESET ALL SETUP” command in the 

maintenance menu (see page 79) is executed.

The following settings are affected when the line mode is 
changed.
• Alarm message language

525(J): Japanese 
525(U)/625: English

• The following menu item names, setting values, or initial 

setting values

AC power switch (rear panel)

Time data display

525U

525(U): NTSC (areas outside Japan)

525J

525(J): NTSC (Japan)

625

625: PAL

Basic menu 

002

CHARACTER H-POSITION

003

CHARACTER V-POSITION

Extended menu