Sony RDR-GX7 Benutzerhandbuch

Seite von 28
21
Controlling Your TV or AV Amplifier (Receiver)
Advanc
ed Hookups and Sett
ings
Controlling Your TV or AV 
Amplifier (Receiver)
You can control your TV with the supplied remote by adjusting 
the remote control’s signal.
If you connected the recorder to an AV amplifier (receiver), you 
can also control the volume with the supplied remote.
Notes
• Depending on the connected unit, you may not be able to control your 
TV or AV amplifier (receiver) with some or all of the buttons below.
• If you enter a new code number, the code number previously entered 
will be erased.
• When you replace the batteries of the remote, the code number may be 
reset to the default setting. Set the appropriate code number again.
Controlling TVs with the remote
Slide the TV/DVD switch to TV.
Hold down [/1.
Enter your TV’s manufacturer code (see 
“Code numbers of controllable TVs” below) 
using the number buttons.
Release [/1.
When the TV/DVD switch is set to TV, the remote 
performs the following:
* If you use number buttons to select the TV’s programme position, 
press -/-- followed by the number buttons for two-digit numbers.
To operate the TV/DVD button 
(for SCART connections only)
The TV/DVD button switches between the recorder and the last 
input source selected on the TV. Point your remote at the 
recorder when using this button. The button works even if the 
TV/DVD switch is set to DVD.
When you connect the recorder to the TV via the SCART 
(EURO AV) jacks, the input source for the TV is set to the 
recorder automatically when you start playback. To watch 
another source, press the TV/DVD button to switch the TV’s 
input source.
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at 
a time until you find the one that works with your TV.
[/1
Turns your TV on or off
2 (volume) +/–
Adjusts the volume of your TV
 (wide mode)
Switches to or from the wide mode of a 
wide-screen TV
t (TV/video)
Switches your TV’s input source
PROG +/–, 
Number buttons, -/--*
Selects the programme position on 
your TV
TV/DVD switch
"
/
1
PROG +/–
2
 +/–
t
TV/DVD
Number buttons, 
-/--
Manufacturer
Code number
Sony
01 (default)
Aiwa
01 (default)
Grundig
11
Hitachi
24
Loewe
08, 45
Nokia
15, 16, 69
Panasonic
17, 49
Philips
06, 07, 08
Saba
12, 13
Samsung
06, 22, 23
Sanyo
25
Sharp
29
Telefunken
36
Thomson
43
Toshiba
38
,
continued