Sony RMO-S551 Benutzerhandbuch

Chapter 2  Getting Started

9

You can hook up a maximum of seven SCSI
peripheral devices to a single host computer
through its SCSI bus.
Use the following Sony SCSI cable to connect
the disk unit.

Notes
• Before connecting the disk unit, be sure to turn

off the disk unit and all other devices on the
SCSI chain.

• If the disk unit is the last device on the SCSI

chain, set the function switch  F on the rear
panel to “1” to turn on the internal terminator.
When it is not the last device, make sure that the
terminator is off (function switch F is set to
“0”).

• The total length of the SCSI cables connected to

a SCSI chain must not exceed six meters (19
feet 8 1/4 inches).

SCSI  ID

to SCSI connector

to AC IN
connector

AC power cord
(supplied)

SCSI cable

SCSI cable

to another
SCSI device

to the host computer or
another SCSI device

to an AC outlet

RMO-S551 Magneto-Optical Disk Unit

The factory default setting for the SCSI ID is “0.”
If necessary, this ID number can be changed
using the SCSI ID switch on the rear panel. Be
sure to turn off the power before making any
changes.
Pushing the “+” button raises the ID number;
pushing the “–” button lowers the ID number.

Notes
• The disk unit will not operate properly unless

the SCSI ID has been set correctly.

• Make sure to select a SCSI ID that has not been

assigned to another SCSI device.

0