GE wwre6260 Benutzerhandbuch

• Switch to a lower sudsing detergent brand and follow 

instructions on package.

• Try less detergent.

• Measure your detergent carefully. Use less soap if you 

have soft water, a smaller load or a lightly soiled load.

• Make sure hose connections are tight at faucets and 

rubber washers are installed. Make sure end of drain 
hose is correctly inserted in and secured to drain facility.

• Check household plumbing. You may need to call 

a plumber.

• Tighten hoses at the faucets and turn the water off after 

each use.

• Check condition of the fill hoses; they should be

replaced every 5 years.

• Use less detergent. Use less soap if you have soft water,  

a smaller load or a lightly soiled load.

• New laundry detergents have been formulated to work 

with cooler water temperatures without affecting 

wash performance.

• Check water temperature control and adjust.

• Turn both hot and cold faucets fully on and make sure 

hoses are connected to correct faucets.

• Turn off the water source and remove the water  

connection hoses from the upper back of the washer. 
Use a brush or toothpick to clean the screens in the
machine. Reconnect the hoses and turn the water back on.

• Make sure house water heater is delivering water 

at 120°F–140°F(48°C–60°C).

• Reset cycle.

• Straighten drain hose and make sure washer is not  

sitting on it.

• Top of drain outlet should be less than 8 ft (2.5 m) 

above floor.

The HANDWASH or CASUALS 

• This is normal. The washer alternates between agitate 

and soak during the HANDWASH and CASUALS cycles to  
get your clothes cleaner with less wear.

• The washer may pause during the spin cycle to remove 

soapy water more efficiently.

This normal. The PerfecTemp feature is designed 

not to activate during a cold rinse cycle to improve 

the energy efficiency of your washer.

• Wait until the water in the water heater is heated to the

correct temperature.

12