honda-power-equipment gxv390 Benutzerhandbuch

The throttle lever is provided with 
holes for attaching a solid wire 
throttle cable.
1. Remove the 5 mm screw and 

the cable holder. Hook the solid 
wire cable end into the throttle 
lever as shown.

2. Move the throttle cable control 

(located on equipment) into the 
FAST (or HIGH) throttle 
position.

3. Move the throttle lever by pulling 

the throttle cable until the 
throttle lever just contacts the 
choke arm. Install the cable 
holder securing the throttle 
cable and tighten it securely.

4. Move the throttle control 

(located on equipment) to move 
the throttle lever to the CHOKE 
position. Verify the engine 
choke rod moves the carburetor 
choke fully closed. Adjust the 
adjusting screw until it just 
contacts the choke arm.                               

5. Start the engine and move the 

throttle lever to the FAST (or 
HIGH) position. Using a 
tachometer, check the engine 
speed. Loosen the cable holder 
bolt and move the throttle cable 
to obtain the top no load engine 
speed specified by the 
equipment manufacturer. 
Tighten the cable holder bolt 
securely.

6. Move the throttle cable control lever to the STOP position and 

confirm that the engine stops.

 

Use a 12 volt battery with an ampere-hour rating of at least 18 AH. 
Coat the terminals and cable ends with grease. Be careful not to 
connect the battery in reverse polarity, as this will short circuit the 
battery charging system.

1. Connect the battery positive (+) cable to the starter solenoid 

terminal as shown.

2. Connect the battery negative (-) cable to an engine mounting bolt, 

frame bolt, or other good engine ground connection.

3. Connect the battery positive (+) cable to the battery positive (+) 

terminal as shown.

4. Connect the battery negative (-) cable to the battery negative (-) 

terminal as shown.

This engine is certified to comply with U.S. EPA and California ARB 
emission regulations using the Impco Beam regulator specified in the 
installation instructions (see below). Honda used this regulator and 
other specific parts and adjustments to demonstrate compliance with 
the emission regulations. Adjustable fuel system parts must have 
U.S. EPA and California ARB approved tamper resistant features to 
limit the available adjustment after the fuel system is correctly 
installed. If an equipment manufacturer did not install your engine in a 
product you will need the installation instructions for the Honda 
certified system (see below). If you choose not to use the Honda fuel 
system you must use a system that has been certified by the fuel 
system manufacturer to be used on this Honda engine. Or if you use 
a fuel system that is not already certified you must have certification 
test data satisfactory to the U.S. EPA or the California ARB. The test 
data must prove that the system will meet the emission standard both 
when the engine is new and at the end of its emission durability 
period (250 hours).
To obtain a copy of the installation instructions for this engine, contact 
an independent Honda engine distributor, or our Customer Service 
Department (page 12).



A battery can explode if you do not follow the correct 
procedure, seriously injuring anyone nearby.

Keep all sparks, open flames, and smoking materials away 
from the battery.