Honeywell 63-4526-01 Benutzerhandbuch

PIR APPLICATION GUIDE FOR TB7200 AND TB7300 SERIES THERMOSTATS

63-4526—01

Typical PIR Detection Pattern

INSTALLATION

WARNING

Electronic controls are static sensitive devices. Discharge yourself properly before manipulation and installing

the thermostat and its accessories.

Short circuit or wrong wiring may permanently damage the thermostat or the equipment. All TB7200 and 7300 Series

thermostats are to be used only as operating controls. Whenever a control failure could lead to personal injury and/or loss

of property, it becomes the responsibility of the user to add safety devices and/or alarm system to protect against such

catastrophic failures.

Table 2. Installation Tips

Fig. 3. Typical Horizontal Angle

Fig. 4. Typical Vertical Angle

Tip Type

Area Of Interest

Explanation

General Installation

PIR Connector

Polarized connector is located at bottom left hand corner of TB7200

or TB7300 Series thermostat

Security Screw

A security screw has been provided in the thermostat box. This

screw should be carefully installed in the intended mounting position

located bottom center of thermostat cover.

Initial Power Up &

Commissioning

PIR Warm up

period

PIR Sensor may take up-to 60 seconds after initial warm up period to

detect movement consistent with typical detection pattern.

Visual indication

(Status of PIR)

Visual indication of PIR activity for commissioning is provided via a

blinking LEDs located on the thermostat cover under the PIR lens.

LEDs will be active while occupant is in field of detection pattern for a

period of 30 minutes after initial power up.

15°

60°

ZONE NOT RELIABLE

0°

M21308

45°

20 FEET

CENTER

M21309