Honeywell CT8775A Benutzerhandbuch

Seite von 20
69-1676—1
6
Mount Decorator Cover Plate (Optional) and Wallplate Directly to Wall
If using the decorator cover plate, pull the wires through 
the wiring hole on the decorator cover plate. Position the 
decorator cover plate against the wall so that the UP 
indicator in the middle of the decorator cover plate is 
pointing up.
Position the wallplate:
If using the decorator cover plate, pull the wires 
through the wiring hole on the wallplate and place 
the wallplate over the decorator cover plate. Turn 
the wallplate until the wiring holes are aligned and 
the two screw holes on the left and right side of the 
wallplate line up with the screw holes on the 
decorator cover plate. You will be inserting the 
screws through these holes into the wall.
If attaching the wallplate directly to the wall, pull the 
wires through the wiring hole on the wallplate and 
position it so that the UP indicator on the wallplate is 
pointing up.
Use a pencil to mark the center of the screw holes on the 
left and right sides of the wallplate.
Remove the wallplate and decorator cover plate (if used) 
and drill two 3/16 in. holes in the wall (if drywall) at the 
locations you marked. For materials such as plaster, drill 
7/32 in. holes where marked. Gently tap the provided 
anchors into the drilled holes until they are flush with the 
wall.
Pull the wires through the wiring holes and reposition the 
decorator cover plate (if used) and wallplate over the 
screw holes.
Attach the decorator cover plate (if used) and wallplate to 
the wall with two 1-in. screws.
Fig. 1. Mount decorator cover plate (optional) and 
wallplate directly to wall (heating-cooling wallplate 
shown).
M19493
WALL ANCHORS (2)
WIRING HOLES
DECORATOR COVER PLATE
WALL PLATE
1 INCH
SCREW (2)