Linak twindrive hb12 Benutzerhandbuch

An actuator is mounted in the bed. This is the electronic unit, 
which moves the bed, when you press the handset. The actuator 
is a LINAK product. LINAK is the world’s leading manufacturer of 
actuator systems. 

A LINAK actuator is reliable and noiseless. It provides a high and 
constant force, and it leaves more space under the bed than any 
other actuator.

The actuator has been constructed with full focus on security. 
At the same time, it has the lowest power consumption in the 
market. 

In short: A LINAK actuator is a quality product, which is built to 
ensure full functionality several years ahead. In this user manual, 
you can fi nd advice and information. 

For further information, please read our user manuals on our 
website http://www.linak.com/products/Dual-Actuators.aspx. 

We recommend that you read the user manual thoroughly 
through before use, so that you will have optimum pleasure with 
the bed and the LINAK actuator many years ahead. 

The TD can accept commands from up to 2 RF handsets.

From the factory, the TD cannot recognize any RF handsets at 
all. Therefore, the end user/bed manufacturer must match it to 
the RF handset before they can control the TD operation.

Conditions which must be fulfi lled prior to activating the 
learning mode:

1. Connect the TD1 to the mains

2. Wait 20 sec. 

3. Activate the reset key on the TD1 by using a fi ngertip, keep

the button pressed (1 - 2 sec.). Push at the same time on a 
button at the HB. HB is now paired to the TD. System is now 
(setup) ready to be used. (This learning mode also works via 
battery pack).

1. Connect the TD3 to the mains

2. Wait 20 sec.

3. Activate the reset key and keep it pressed until the motor stops.

4. Release the reset key

5. Activate the reset key on the TD3 by using a pen, keep the

button pressed (1 - 2 sec.). Push at the same time on a button 
at the HB. HB is now paired to the TD. System is now (setup) 
ready to be used. (This learning mode also works via battery 
pack).