Honeywell T100 Benutzerhandbuch

13

62-3048—2

The VA8200A001 Valve Cartridge Changing Tool enables the 

user to remove, and clean or replace the valve cartridge while 

the valve remains pressurized. Boiler shutdown is not required.

Exercise extreme caution when working with hot liquid.

Wear eye protection to prevent injury.

To remove the cartridge, perform the following:

1. Remove controller and loosen valve cartridge slightly 

using a 19mm socket wrench (A,B). See Fig. 20.

2. Tighten VA8200A Cartridge Changer to valve body 

(A,B), close drain cock (C), and turn tool handle ccw to 

unscrew cartridge (D). See Fig. 21.

3. Pull handle out to clear VA8200A ball valve (A), close 

ball valve (B), and open drain cock to remove excess 

water and steam from chamber (C). See Fig. 22.

4. Unscrew end cap (A) and remove cartridge from 

chamber (B). See Fig. 23.

5. Clean or replace cartridge.

To reinstall cartridge into the valve, use the same process and 

figures. Perform steps in reverse order. All figure arrows are 

backwards (except Fig. 20, arrow A). Proceed as follows:

1. Replace cartridge into chamber (B) and screw end cap 

onto VA8200A (A). See Fig. 23.

2. Close drain cock (C), open ball valve (B), and push 

handle in (A). See Fig. 22.

3. Turn tool handle cw to screw in cartridge (D), open drain 

cock to drain chamber of remaining water and steam (C), 

and loosen VA8200A Cartridge Changer from valve body 

(B,A). See Fig. 21.

4. Tighten valve cartridge using a 19mm socket wrench 

(A,B) and replace controller. See Fig. 20.

M16274

M16273

C