Panasonic DP-8060 Bedienungsanleitung
Network Configuration
4
Before executing the procedures
described below, make sure the Print
On Line LED is lit.
described below, make sure the Print
On Line LED is lit.
1
Press the Function key.
2
Select "GENERAL SETTINGS".
3
Select "09 Key Operator Mode".
4
Enter the Key Operator's password
(8 digits), and then select "OK".
(8 digits), and then select "OK".
5
Scroll to "05/11" screen, and then
select "22 DHCP Default".
If DHCP Default is set to "Yes",
change the setting to "No", and
then select "OK".
select "22 DHCP Default".
If DHCP Default is set to "Yes",
change the setting to "No", and
then select "OK".
6
Select "23 TCP/IP Address".
Follow the procedure below if your network is not configured with the DHCP server, and the TCP/IP parameters must be
setup manually.
setup manually.
- IP Address
- Subnet Mask
- Default Gateway
- Subnet Mask
- Default Gateway
●
Default password is "00000000".
To change this password, open "50 Key
Operator Password" in the General Setting
(For key operator), and then re-enter the new
password.
To change this password, open "50 Key
Operator Password" in the General Setting
(For key operator), and then re-enter the new
password.
2
1
Function Key
Print On Line LED
●
Please wait until the Print On Line LED is ON
before pressing the Function Key.
before pressing the Function Key.
Setting up the Network Configuration