Marantz PM-14S1 Benutzeranleitung
7
Playback
Settings
Tips
Appendix
ENGLISH
Connections
Preparation
NOTE
šDisconnect this unit’s power plug from the power outlet before connecting the speakers.
šConnect the speaker cables so they do not stick out of the speaker terminals. The protection
šConnect the speaker cables so they do not stick out of the speaker terminals. The protection
circuit may be activated if the wires touch the rear panel or if the + and – sides touch each
other (
other (
vpage 24 “Protection circuit”).
šNever touch the speaker terminals while the power cord is connected. Doing so could result
in electric shock.
šUse speakers with an impedance of 4 – 8 Ω/ohms.
Cables used for connections
Provide necessary cables according to the devices you want to connect.
Speaker cable
Audio cable
R
L
R
L
Remote connector cable
Connections
Connecting the speakers
Connecting the speakers cables
Carefully check the left (L) and right (R) channels and + (red) and – (white) polarities on the
speakers being connected to the unit, and be sure to connect the channels and polarities
correctly.
speakers being connected to the unit, and be sure to connect the channels and polarities
correctly.
1
Peel off about 3/8 inch (10 mm) of sheathing from the tip of
the speaker cable, then either twist the core wire tightly or
apply solder to it.
the speaker cable, then either twist the core wire tightly or
apply solder to it.
2
Turn the speaker terminal counterclockwise to loosen it.
3
Insert the speaker cable’s core wire to all the way into the
speaker terminal.
speaker terminal.
4
Turn the speaker terminal clockwise to tighten it.
Spade lug connector
When using a banana plug
Tighten the speaker terminal firmly
before inserting the banana plug.
before inserting the banana plug.