Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Marantz
  4. PM-14S1
  5. Benutzeranleitung

Marantz PM-14S1 Benutzeranleitung

Download
Seite von 33
18
ENGLISH
Settings
INPUT SELECTOR
DISPLAY
P.DIRECT IN
X
Setting ID number for F.C.B.S
When the unit is turned on, the display shows the ID number 
for three seconds.
For a master unit, ID number 1 needs to be assigned.
For a slave unit, set any of ID numbers 2 to 4.
1
While holding DISPLAY on the unit, press 
X
.
2
Turn INPUT SELECTOR on the unit to select an 
ID number.
3
Turn the unit off.
4
Again turn the unit on.
šThe setting is saved.
šThe unit registered as a slave shows “SLAVE” on the 
display. 
NOTE
šIf using this unit by itself as a stereo amplifier, set the ID 
number to “0” (Default setting is “0”). 
šIf the ID number is set to a number other than “0”, this unit 
cannot be used for standalone operation. 
Setting the power amp direct mode
When a pre-amplifier is connected to this unit and the unit is 
used as a power amplifier, follow the instructions below to 
turn power amp direct mode on. 
šThe power amp direct mode is turned off in the factory 
default settings. 
Turning power amp direct mode on
Press and hold P.DIRECT IN on the unit for 3 
seconds or longer.
“POWER AMP DIRECT” is appears on the display . 
Turning power amp direct mode off
Press and hold P.DIRECT IN on the unit for 3 
seconds or longer.
“POWER AMP DIRECT” disappears from the display. 
NOTE
šWhen the power amp direct mode is on, adjustment of the 
volume, balance and tone on the main unit has no effect. 
Adjust the volume on the pre-amplifier.
šWhen the power amp direct mode is on, the main unit outputs 
at maximum volume. Check the output level on the input 
device before playing it and adjust the volume accordingly.