Clarion CM1001 Benutzerhandbuch

CM-HS1 handsfree owners manual

Do not install CM-HS1 on or near air conditioner duct to avoid condensation. Condensation

will result in some electronic component to malfunction, damaging the unit. Also, avoid

installing the unit directly in the path of front speaker of the car stereo (voice route) to

minimize echo.

Pairing CM-HS1
Before you start using CM-HS1 for the first time, you must pair it to your handphone. Pairing

activities differ from phone to phone. Please refer to handphone user documentation for

pairing, and follow the steps below:

1. Power on CM-HS1 by powering the car stereo unit. A Blue LED is lighted to 

indicate power.

2. Simultaneously press the “+” and “-“ buttons on CM-HS1. Blue and Red LEDs 

will blink to indicate readiness for pairing.

3. Initiate Bluetooth pairing in the handphone to pair it with CM-HS1. To do this,

please refer to the user documentation for the handphone.

4. The default name is “CM-HS1”.
5. When asked, the passkey is 0000. If pairing is successful, CM-HS1 will stop 

blinking, and only the Blue LED is lighted again.

6. During usage (talking on the phone), both Blue and Red LEDs will be lighted

(not blinking).

Installing CM-HS1
It is important that CM-HS1 is installed with the internal microphone facing towards the user

(driver). Use the Visor Clip (included) to fix CM-HS1 to the car sun visor, and route the main

cable properly.  Use the special screw given to tighten CM HS1 to the Visor Clip if necessary.

If installing CM-HS1 anywhere else, care must be taken so as not to damage the connector

on the unit. Test for the microphone strength during normal conversation and adjust the

location accordingly.

CM-HS1 handsfree owners manual

CM-HS1

Screw

Visor

Clip

Car

Sun

Visor

Main Cable

CM-HS1  is  an  In-Car  hands  free  module  offering  a  high-quality  Bluetooth

TM

 

wireless

communication solution for in-vehicles environment. The unit works with any Bluetooth

TM

mobile telephone supporting headset profile version 1.0B/1.1.

After initial setup, Bluetooth™ connection between handphone and CM-HS1 is automatically

established when the ignition is switched on **. Incoming calls are accepted by pressing

the acceptance button. Muting the car stereo automatically, telephone sound is routed

through car speaker.

CM-HS1 handsfree owners manual

Visor Clip Slot

“-” Button

Internal Microphone Window

Main Cable

Connector

“Acceptance” Button

LED Window
External Microphone Input
“+” Button