Rohde & Schwarz Inc NV830X Benutzerhandbuch

2098.0188.72

- 8.22 -

E-1

4. Disconnect all cables from the rear of the exciter switch. 

5. Undo the fastening screws on the exciter switch. 

6. Pull the exciter switch from the transmitter rack.

To install the unit in the transmitter, reverse the procedure used to remove it. 

1. Connect the cables to the exciter switch according to the labeling (see yellow cable col-

lars).

2. Undo the latch on the guide rails. Simultaneously press the safety lever on the right side

down and on the left side up, and slide the rackmount into the rack. 

3. Retighten the captive screws on the front panel of the R&S NetCCU800 and exciter.