Silex SX-550-0700 E1038 Benutzerhandbuch
Produktcode
E1038
8. You do not need to change any of the settings
in this window. Click the Serial Settings
button to configure the serial port.
button to configure the serial port.
9. Configure the serial port settings so that they
match the settings on your device. For
example, if your device is set for 9600bps,
odd parity, and XON/XOFF flow control, you
must change the settings on the SX-550 to
these settings
example, if your device is set for 9600bps,
odd parity, and XON/XOFF flow control, you
must change the settings on the SX-550 to
these settings
Click OK when you are finished to return to
the Server Configuration window and then
click OK again.
the Server Configuration window and then
click OK again.
10. Click OK to save your changes and reset the
SX-550. You can now use the SX-550 on
your network. You may skip the remaining
sections of this chapter, although this
information is useful for future reference.
your network. You may skip the remaining
sections of this chapter, although this
information is useful for future reference.
First-Time IP Address Configuration
If you are configuring the SX-550 from a non-Windows computer or if you cannot use an Ethernet
connection, you must first configure the SX-550 IP address. Note that it is only necessary to perform this
connection, you must first configure the SX-550 IP address. Note that it is only necessary to perform this
Part Number 40183-101
Silex SX-550 Developer's Guide
Page 24
NOTE: Skip this section if you have already configured the SX-550 IP address with ExtendView