Brodit 513361 Merkblatt

Seite von 2
1.
2.
INSTALLATION INSTRUCTIONS
4.
3.
Important Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external
fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source.
Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive
tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that
does not get hot! Connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle
or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by
the ignition switch of the vehicle. Installation of the holder: Please read all of the instructions and look at the
pictures before attaching the holder. 1. Loosen the screw in the center of the holder so you can remove the tilt
swivel attaching plate on the back. Place the attaching plate onto the desired position. Screw the attaching plate
into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the
tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 2. To place the device in
the holder: Place the lower part of the device in the holder, then flip/press the upper part forwards so it snaps into
place in the holder. Slide the device sideways carefully into the holder until you feel that it is properly attached to
the connector. 3. To remove the device from the holder: Press upwards on the upper part of the holder, in the
same time pull the upper part of the device out from the holder and then lift the device up and out from the holder.
4. The holder is in place.
2 (2)