TP-LINK TD-W8960N Benutzerhandbuch

PC, and the NAT and SPI Firewall will be closed. Sometimes you can think it as bridge while 
PPP dialing in the router. It’s a special feature deployed by some ISP. Unless your ISP 
specifically requires this setup, do not select it. 

¾

  Use Static IPv4 Address: If your ISP gives you a static WAN, Gateway and DNS IP address, 

select this option to enter them manually. 

¾

  Enable PPP Debug Mode: Select this option to debug the PPP function and you can see 

many PPP log information in the System Log. Only PPP has this debug Mode. 

¾

  Bridge PPPoE Frames Between WAN and Local Ports: Select this option to start PPP 

connection in your local PC. 

¾

  Enable  IGMP Multicast Proxy: IGMP (Internet Group Management Protocol) is used to 

manage multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote 
configuration for client devices, such as the Router. The default value is disabled, and if you 
are not sure, please contact your ISP or just leave it. 

5.  Select a preferred wan interface as the system default gateway in Figure 4-11 and click Next. 

 

Figure 4-11 

6.  Configure the DNS Server Addresses on the screen below and click Next. 

 

Figure 4-12 

¾

  Obtain DNS info from a WAN Interface: You can select this option to automatically get DNS 

server information from the selected WAN interface. 

¾

  Use the following Static DNS IP Address: You can select this option to manually enter the 

primary and /or optional secondary DNS server IP addresses provided by your ISP. 

25