Clarion CZ703E Benutzerhandbuch

English

4

CZ703E

•   The USB memory stick may stick out when inserted,so it may cause danger during driving. 

When  connect  USB  memory  stick  to  the  source  unit,  please  use  the  USB  extension 

cable(CCA-755).

•   The USB memory sticks must be recognized as “USB mass storage class” to work properly. 

Some models may not operate correctly.

   When using the USB memory stick, we recommend that you backup your data stored on it 

before using a personal computer etc.

•   Data files may be broken when using USB memory sticks in the following situation: When 

disconnecting the USB memory stick or turning the power off during reading data.

   When affected by static electricity or electric noise.

   Connect/disconnect the USB memory stick when it is not accessed.

•    Connecting with the computer is not covered.

For a longer service life, be sure to read the following cautions.

•  Do not allow any liquids on the unit from drinks, umbrellas, etc. Doing so may damage the 

internal circuitry.

•  Do not disassemble or modify the unit in any way. Doing so may result in damage.

•  Do not let cigarettes burn the display. Doing so may damage or deform the body.

•  If a problem should occur, have the unit inspected at your store of purchase.

•  The remote control unit may not work if the remote control sensor is exposed to direct sunlight.

•  Use a soft, dry cloth and gently wipe off any dirt or dust. 

•  For tough dirt, apply some neutral detergent diluted in water to a soft cloth, wipe off the dirt 

gently, then wipe again with a dry cloth. 

•  Do not use benzene, thinner, car cleaner, etc., as these substances may damage the body or 

cause the paint to peel. Also, leaving rubber or plastic products in contact with the body for long 

periods of time may cause stains.

The control panel can be detached to prevent 

theft. When detaching the control panel, keep 

it in the safety place and prevent scratches.

W e   r e c o m m e n d   t a k i n g   t h e   D C P 

(DETACHABLE CONTROL PANEL) with you 

when leaving the car.

1.  Press the [

SRC / 

 ] button (1 sec.) to turn 

off the power.

2.  Deeply push in [

] button to unlock 

the DCP.

3.  Hold  the  side  popped  out,  remove  the 

DCP.

1.  Hold the DCP and ensure that the panel 

faces towards you. Set the right side of the 

DCP into the DCP bracket. 

2. Press the left side of the DCP until it locks.

Hold the DCP, as shown in the figure below, 

and put it into the supplied DCP case. 

•   The  DCP  can  easily  be  damaged  by 

shocks. After removing it, be carefully not 

to drop it or subject it to strong shocks.

•   Once the [

] button is pressed and 

DCP is unlocked, car vibrations can cause 

the DCP to fall

•   The  connector  for  the  main  unit  and 

DCP is extremely important. Be careful 

not  to  damage  it  by  pressing  on  it  with 

fingernails, screwdrivers, etc.

If the DCP is dirty, wipe off the dirt with a soft, 

dry cloth only.

DCP case

DCP