Brodit 527661 Merkblatt
1.
2.
INSTALLATION INSTRUCTIONS
4.
3.
Please read all of the instructions and look at the pictures before attaching the holder. Important Note: The
charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be
installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the
cable from the holder into the vehicle dashboard and secure the charger unit in place. Ensure the charger unit is
securely mounted behind the dashboard in a well ventilated area that does not get hot! Route the power cable
from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire
to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12 Volt
power supply in the vehicle that is controlled by the ignition switch of the vehicle.
Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel
attaching plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into
place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt
swivel. 3. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it
slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw
until the holder is firmly in place, but still can be adjusted. 4. The holder is in place.
charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be
installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the
cable from the holder into the vehicle dashboard and secure the charger unit in place. Ensure the charger unit is
securely mounted behind the dashboard in a well ventilated area that does not get hot! Route the power cable
from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire
to a Negative Ground connection of the vehicle or the vehicle chassis. 2. Connect the Red wire to a 12 Volt
power supply in the vehicle that is controlled by the ignition switch of the vehicle.
Installation of the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel
attaching plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into
place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt
swivel. 3. Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it
slightly tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw
until the holder is firmly in place, but still can be adjusted. 4. The holder is in place.
2 (2)