Brodit 513673 Merkblatt
1.
2.
INSTALLATION INSTRUCTIONS
4.
3.
Read all of the instructions and look at the pictures before attaching the holder. Important Note: The charger unit
is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then
connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the
holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure
the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If
you are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within
easy reach of any GPS or charging adapters. Route the power cable from the charger unit to the power supply
source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the
vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is
controlled by the ignition switch of the vehicle. How to mount the holder: 1. Loosen the screw in the center of the
holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired
position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate
so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull
the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward
the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 3. To place the device
in the holder: Slide the device sideways into the holder so the charging device connects. To remove the device
from the holder: Slide the device sideways out from the holder. 4. The holder is in place.
is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then
connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the
holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure
the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If
you are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within
easy reach of any GPS or charging adapters. Route the power cable from the charger unit to the power supply
source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the
vehicle or the vehicle chassis. 2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is
controlled by the ignition switch of the vehicle. How to mount the holder: 1. Loosen the screw in the center of the
holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired
position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate
so the screw fits in the hole in the tilt swivel. Screw a few turns on the screw, just so the thread starts to pull. Pull
the holder toward you and hold it slightly tensed, in the same time tighten the screw so the holder is pulled toward
the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted. 3. To place the device
in the holder: Slide the device sideways into the holder so the charging device connects. To remove the device
from the holder: Slide the device sideways out from the holder. 4. The holder is in place.
2 (2)