Janitza UMG 96RM-M 5222039 Datenbogen

34

The UMG 96RM-M is operated using buttons 1 and 
2. Measured values and programming data appears 
on a liquid crystal display. 

A distinction is made between display mode and pro-
gramming mode. The accidental changing of program-
ming data is prevented by the entry of a password.

In the display mode, you can scroll between 
the programmed measured value displays using 
buttons 1 and 2. All factory-set measured value displays 
listed in section 1 can be called up. Up to three measured 
values are displayed per measured value display. 
The measured value relaying allows select measured 
value displays to be shown alternately after a settable 
changeover time. 

In the programming mode, the settings required 
for operating the UMG 96RM-M can be displayed 
and changed. Pressing buttons 1 and 2 simultaneously 
for about one second calls up the programming mode 
after the password prompt. If no user password was 

programmed, the user arrives directly in the first 
programming menu. Programming mode is indicated 
by the text “PRG” on the display. 
Button 2 can now be used to switch between 
the following programming menus:

- current transformer, 
- voltage transformer, 
- parameter list. 

If the device is in programming mode and no button has 
been pressed for approximately 60 seconds or if buttons 
1 and 2 are pressed simultaneously for approx. one sec-
ond, the UMG 96RM-M returns to display mode.