Beha Amprobe TMD-56 Thermometer USB Data Logger 3730138 Benutzerhandbuch

8

Setup Mode
Press the “SET[ ]” button in normal mode to switch to 
setup mode, the indicator “SET” is shown on the left 
side of the display. To switch back to normal mode, press 
“SET[ ]” button.

Wireless Mode
Press the “ ” key for more than two seconds to start 
wireless function. Press the “ ” key again for another 
two seconds to stop wireless function. The wireless mode 
will shut down if there is no wireless signal for two 
minutes.
To SET CH/ID to 00,00, by pressing “T1-T2” key and “
” power key for more than 6 seconds with the meter 
powered down. The meter will set channel and ID to 
00,00 status. The second display will show 00, which 
means that the channel and ID has been set to 00.

To check the channel and ID of the meter
When the meter is off press “

” key and “ ” for 5 

seconds, LCD’s main display will show channel number, 
the second display will show ID number.

The following functions can only be used in the normal 
mode.

“ ” Power Button
The “ ” key turns the thermometer on or off. When 
enter data REC mode, the power off function is disabled.

“[LIMITS]” Button (only Main display)
The limits function will alert the user when a 
measurement exceeds a specified limit. To set the limit 
values, refer to limits function in the setup mode. Press 
the “[LIMITS]” button to activate the limits function; the 
word “LIMIT” should be displayed on the LCD.