Reely Model car with remote control (9801) 9801 Datenbogen
Produktcode
9801
23
Charging the enclosed driving battery
• Remove the driving battery from the vehicle to charge it (first remove the safety screw of the battery
compartment lid, then open the battery compartment lid).
• Place the driving battery on a heat-resistant, inflammable surface when charging.
• Plug the charger into a suitable, easily accessible AC outlet. Then connect the NiMH drive battery with the
corresponding connectors of the charger plug .
If the vehicle battery is connected to the charger and this is not yet connected to the power outlet, the
LED may light up green on the charger. This is normal.
LED may light up green on the charger. This is normal.
• While charging, the LED is red.
• The charger and drive battery heat up when charging. Leave enough distance between the charger and the
drive battery, never place the drive battery on the charger.
• Remove the battery from the charger when it is fully charged. Depending on how empty/full the drive battery
was before charging started, charging may take up to 3 hours.
When fully charged, the LED changes from red to green on the charger.
c) Inserting the Batteries/Rechargeable Batteries
• Always observe correct polarity of batteries/rechargeable batteries and the connection of a rechargeable drive
battery in the vehicle (note plus/+ and minus/-) when inserting the batteries.
• Never mix batteries and rechargeable batteries! Use batteries or rechargeable batteries for the transmitter and
vehicle.
• Always replace the whole set of batteries/rechargeable batteries. Never mix fully charged batteries/rechargeable
batteries with partially discharged ones. Always use batteries or rechargeable batteries of the same type and
manufacturer.
manufacturer.