Beko D1 5081 BS Benutzerhandbuch

EN

9

3.   Important: Tighten all lock nuts up 

again.

Important:

•   The water supply pressure required 

to run the machine must be 1-10 

bar (0,1 – 10 MPa). (Practically, it 

is necessary to have 10 – 80 liters 

of water flowing from the tap in 

one minute to have your machine 

run smoothly.) Attach a pressure-

reducing valve if the water pressure 

is higher.

•   Connect the special hoses supplied 

with the machine to the water intake 

valves on the machine. The hose 

bearing the “red” sign (90°C max) 

is the hot water inlet and the hose 

bearing the “blue” sign (25°C max) is 

for the cold water inlet.

•  In order to prevent water leakage 

that may occur at the connection 

points, there are rubber seals (4 

seals for the models with double 

water inlet and 2 seals for other 

models) attached to the hoses. 

These seals should be used at the 

tap and machine connection ends of 

the hoses. The plain end of the hose 

fitted with a filter must be attached 

to the tap and the elbowed end 

must be attached to the machine. 

Tighten the nuts of the hose well by 

hand; never use wrenches to tighten 

the nuts.

•  Open the taps completely after 

making the hose connection to 

check if there is any water leakage 

at the connection points. Turn off 

the tap and remove the nut in case 

of any leakage. Retighten the nut 

carefully after checking the seal. 

To prevent any water leakage and 

any other damage to be caused by 

it, keep the taps closed when the 

machine is not in use.

•  Models with a single water inlet 

should not be connected to the 

hot water tap. Laundry may be 

damaged or the appliance may 

switch to protection mode and not 

work.

When returning the appliance to its 

place after maintenance or cleaning, 

care should be taken not to fold, 

squeeze or block the hoses.

The water discharge hose can be 

attached to the edge of a washbasin or 

bathtub. The drain hose should be firmly 

fitted into the drain as to not get out of 

its housing.

Important:

•   The end of the drain hose can 

be directly connected to the 

wastewater drain or to the 

washbasin. The fitting must 

alwasy be secured in all types of