Whirlpool oortable spa Benutzerhandbuch
www.clearcreekspas.com
www.clearcreekspas.com
IMPORTANT SAFETY INFORMATION
READ ALL INSTALLATION INSTRUCTIONS
Jacuzzi Whirlpool Bath does not recommend spa water
temperatures in excess of 40
temperatures in excess of 40
°
C (104
°
F). High water
temperatures in excess of 40
°
C (104
°
F) and prolonged
periods of use can raise the internal human body tempera-
ture excessively and impair the body’s ability to regulate its
internal temperature. Limit your initial use of the spa to
ture excessively and impair the body’s ability to regulate its
internal temperature. Limit your initial use of the spa to
10-15 minutes. High body temperatures affect people
differently; consult your physician about your safety and
comfort before using the spa.
differently; consult your physician about your safety and
comfort before using the spa.
The elderly, the infirm, and children should not use the spa
unattended. Infants should not be permitted in the spa at
water temperatures over 38
unattended. Infants should not be permitted in the spa at
water temperatures over 38
°
C (100
°
F). Pregnant women
and people with heart conditions should consult their phy-
sicians before using the spa at water temperatures over
38
sicians before using the spa at water temperatures over
38
°
C (100
°
F).
Extra care should be taken when using the spa and con-
suming alcoholic beverages. Alcohol, drugs, or certain
medications such as tranquilizers affect a person’s ability to
withstand high temperatures and may produce dangerous
effects.
suming alcoholic beverages. Alcohol, drugs, or certain
medications such as tranquilizers affect a person’s ability to
withstand high temperatures and may produce dangerous
effects.
Keep body, hair, and clothing a minimum of 300mm (12
inches) away from suction fitting and skimmers at all times
when the spa is operating. Hair longer than shoulder length
should be secured close to the head, or a bathing cap
should be worn. Do not remove the suction grilles! They
are safety devices and must always be in place on the
suction fitting to minimize the potential hazard of hair
entanglement or body entrapment.
inches) away from suction fitting and skimmers at all times
when the spa is operating. Hair longer than shoulder length
should be secured close to the head, or a bathing cap
should be worn. Do not remove the suction grilles! They
are safety devices and must always be in place on the
suction fitting to minimize the potential hazard of hair
entanglement or body entrapment.
The wet surface of the spa is slippery. Use care when
entering and exiting.
entering and exiting.
While the optional spa cover is rigid, it is not designed to
support any weight. Therefore, as a safety precaution, do
not sit, stand or lie on it.
support any weight. Therefore, as a safety precaution, do
not sit, stand or lie on it.
The spa must be installed with adequate access and water
drainage system. (See Installation Instructions.)
drainage system. (See Installation Instructions.)
When using the electrical equipment, basic safety
precautions should always be followed:
precautions should always be followed:
This unit is equipped with an earth leakage circuit breaker
(ELCB) located in the electrical cabinet. Check at least
once a month to be sure this is operational. (The procedure
for testing is described on page 7 of this manual.)
once a month to be sure this is operational. (The procedure
for testing is described on page 7 of this manual.)
Do not use electrically connected devices such as televi-
sion, radio, or stereo speakers, lights, cooking devices, or
telephones within 1.5m (5 feet) of the spa while the spa is
being used. Lighting fixtures must not be located directly
above or within 1.5m (5 feet) of the spa. If located with 3m
(10 feet) of the spa, they must be on a circuit protected by
an ELCB.
sion, radio, or stereo speakers, lights, cooking devices, or
telephones within 1.5m (5 feet) of the spa while the spa is
being used. Lighting fixtures must not be located directly
above or within 1.5m (5 feet) of the spa. If located with 3m
(10 feet) of the spa, they must be on a circuit protected by
an ELCB.
Do not apply power to the spa unless it is filled with water
to the normal water level, which is to the water level
indicator mark on the skimmer frame. Activating the spa
when there is an insufficient amount of water can damage
the circulation pump and may cause a fire.
to the normal water level, which is to the water level
indicator mark on the skimmer frame. Activating the spa
when there is an insufficient amount of water can damage
the circulation pump and may cause a fire.
Read manufacturer’s safety information provided with all
optional equipment.
optional equipment.
Save These Instructions for Future Use.
Owner's Record
Date Purchased
Purchased From
Installed By
Spa Serial Number Model #7700000
(See page 2 for location of serial number.)