Bunn FPG Benutzeranleitung

5

 

The use of a damp cloth rinsed in any mild, nonabrasive, liquid detergent is recommended for cleaning all

surfaces on Bunn-O-Matic equipment. Care should be taken not to scratch the hopper or windows with any 

abrasive material. Regular cleaning will keep your grinder looking new for years.

COFFEE GRINDING       

1.  Set the Rotary Batch Selector Switch for the desired batch size and visually inspect the hopper for an ample 

supply of whole bean coffee.

2.  Carafe brewing: Place a paper filter into the brew funnel. Insert the funnel into the rails and push until it 

stops.

3.  French Press brewing: Place French Press on grinder base and push towards rear until it stops.

4.  Momentarily press Off/On/Start switch to the “START” lower position and release. The grinding action will 

stop automatically after the preset amount of ground coffee is dispensed into the funnel.

5.  Remove the funnel from the grinder and level the bed of grounds by gently shaking.

6.  The loaded funnel is now ready for use in any commercial drip coffee brewer according to the manufacturer’s 

instructions.

36783 072210

1.  WARNING - Unplug grinder before removal of any panel or grind chamber housing parts.

2.  Empty all beans from the hopper.

3.  Plug-in the grinder, place funnel with filter into funnel rails. Press the Off/On/Start switch to the “START” 

lower position and release. Run a few grind cycles until all the coffee in the grind chamber is dispensed and 

disconnect grinder from the power source.

4.  Remove the funnel with filter and carefully tip the grinder over on it’s back.

5.  Loosen the three #10-32 screws holding the cone. Rotate the cone clockwise and remove.

6.  Remove the two #10-32 screws securing burr housing cap assembly to the burr housing and remove burr 

housing cap assembly.

7.  Remove load disc and slide rotor with lower burr, spring and brass bushing off of the motor shaft.

8.  Clean the grind chamber and all parts with a dry non metallic bristle brush and wipe with a dry clean cloth.

9.  Reinstall brass bushing (flanged end first), spring and rotor with lower burr onto the motor shaft. Reinstall 

load disc flat side toward rotor and burr housing cap assembly to the burr housing.

10. Refer to Initial Set-up/Adjustments section to vary grind or weight of dispensed coffee if necessary.

Bunn-O-Matic

®

 Corporation recommends that preventive maintenance be performed at regular intervals. Maintenance 

should be performed by a qualified service technician. For Technical Service, contact Bunn-O-Matic

®

 Corporation at 

1-800-286-6070.
NOTE: Replacement parts or service caused by failure to perform required maintenance is not covered by warranty.

6-Month 

Weekly Cleaning plus replace the dechaffer assembly.

1.  On grinders with slide plates check the slide plates and clean. 

2.  Inspect and clean/replace burrs and grind chamber if necessary.

3.  Adjust the burrs and grind time to your specifications for particulate size and throw weight.