Bunn BREWWISE Dual TF DBC Benutzerhandbuch

Page 29

NOTE:  The procedure to enter the PULSE BREW  

function must be performed prior to following the 
steps listed below.

1.  Press and release YES. The display should now 

read EASY PULSE SETUP. 

2. Press 

and 

release 

NO. The display will read ENTER 

3. Press YES to proceed. The display should now 

read 1st ON TIME X:XX.

4. Using 

(-) and (+) set the amount of time the fl ow 

of water into the funnel will be on.

5. When 

fi 

nished, 

press DONE. The display will now 

read OFF TIMES: X:XX.

6.  Using (-) and (+) set the amount of time the fl ow 

of water into the funnel will be off.

7. When 

fi 

nished, 

press DONE. The display will now 

read LAST ON:  X.XX

8.  Using (-) and (+) set the amount of time the water 

will be on to complete the brew.

9.  When fi nished, press DONE. The display will show 

the three times just entered for that batch size. After 
a 5 second delay, the display will read 3 BATCHES 
DONE?

10. If other batch sizes need to be modifi ed, press 

12. Press a different batch size and repeat steps 3 

through 7. Repeat until all the desired batch sizes 
are set for the left side.

13. When fi nished press YES in 3 BATCHES DONE?. 

The display will then read DRIP TIME.

14. Press and release either of the ON/OFF switches 

located on the front switch panel to exit the SET 
PULSE BREW function and return to the MAIN 
SCREEN.

NOTE: Pressing the upper right hidden button before 
reaching the fi nal setting screen exits the setup and 
retains the old values.