StorageTek Host Software Component 6 Benutzerhandbuch

1st ed., 6/30/04 - 312579601

indicates a T9940A transport.

indicates a 3490E-image T9940A transport. 

indicates a 3590-image T9940A transport. 

indicates a T9940B transport.

indicates a 3490E-image T9940B transport. 

indicates a 3590-image T9940B transport. 

specifies which Cartridge Access Port(s) is being used for the operation. 

This utility ejects scratch volumes to the specified CAP(s) only. EJECt searches for 
scratch volumes only in the LSMs that contain the specified CAP(s).

Note: If a CAP has not been specified, EJECt determines the CAP to use based 
upon the CAPPref command setting (refer to ‘‘CAP Preference (CAPPref) 
Command and Control Statement’’ in the HSC Operator’s Guide). 

If a CAP preference has not been specified, the HSC displays a message and waits 
until the user enters a CAPPref value. Pass-thrus can be made to CAPs specified by 
CAPPref. 

cap-list identifies the Cartridge Access Port(s). The cap-list requires 
explicitly specified CAPids separated by commas. A CAPid range is not 
allowed. 

If more than one CAPid is specified, the elements must be separated by 
blanks or commas, and the entire list must be enclosed in parentheses. If 
no CAP is specified, one is chosen in each ACS. 

The format for cap-id is AA:LL:CC where AA is the ACS number 
(hexadecimal 00-FF), LL is the LSM number (hexadecimal 00-17), and 
CC is the CAP number. 

Allowable values for CC are: 

• For 4410 and 9310 LSMs, standard 21-cell CAP or the right-hand 40-cell 

enhanced CAP