Sony MULTI CHANNEL AV RECEIVER STR-DG710 Benutzerhandbuch

 

 

 

 

 

 

 

• Select the appropriate input using the input 

buttons.

• Set your TV to the appropriate input mode.
• Move your audio components away from 

the TV.

• Assign the composite video input to the 

DMPORT input correctly.

• Depending on the DIGITAL MEDIA 

PORT adapter video output may not be 
possible.

• Check the HDMI connection.
• Depending on the playback component, 

you may need to set up the component. 
Refer to the operating instructions 
supplied with each component.

• Check that the components are connected 

correctly.

• Select the source component using the 

input buttons.

• Use a 75-ohm coaxial cable (not supplied) 

to connect the receiver to an outdoor FM 
antenna (aerial) as shown below. If you 
connect the receiver to an outdoor antenna 
(aerial), ground it against lightning. To 
prevent a gas explosion, do not connect the 
ground wire to a gas pipe.

• Check that the antennas (aerials) are 

connected securely. Adjust the antennas 
(aerials) and connect an external antenna 
(aerial), if necessary.

• The signal strength of the stations is too 

weak (when tuning in with automatic 
tuning). Use direct tuning.

• Make sure you set the tuning interval 

correctly (when tuning in AM stations 
with direct tuning).

• No stations have been preset or the preset 

stations have been cleared (when tuning by 
scanning preset stations). Preset the 
stations (page 56).

• Press DISPLAY repeatedly on the receiver 

so that the frequency appears on the 
display.

• Make sure that you are tuned to an FM 

RDS station.

• Select a stronger FM station.

AM

Receiver

To ground

Ground wire 
(not supplied) 

Outdoor FM antenna (aerial)