Siemens Outboard Motor S120 Benutzerhandbuch
Interfaces
8.2 Electrical connections
Temperature sensor connection
A connector is used to connect the signal cable to the SME12x (Sensor Module External)
whose output is connected to the converter. Refer to the figures relating to system
integration in the section titled "System requirements", as well as the connection overview
below.
%XLOWLQWRUTXHPRWRU
):
):
1RWH
37&&KDUDFWHULVWLFWR',19'(3DUW',1',1
%HIRUHFRPPLVVLRQLQJWKHPRWRUPDNHVXUHWKDWWKHVKXWGRZQFLUFXLWYLDWKH
60([IXQFWLRQVSURSHUO\
37&&KDUDFWHULVWLFWR',19'(3DUW',1',1
%HIRUHFRPPLVVLRQLQJWKHPRWRUPDNHVXUHWKDWWKHVKXWGRZQFLUFXLWYLDWKH
60([IXQFWLRQVSURSHUO\
(YDOXDWLRQ
37&r&
37&r&
37&r&
DQG.7<
37&r&
37&r&
37&r&
DQG.7<
6,1$0,&66
37&r&37&r&
37&r&37&r&
.7<
J\
SN
JQ
\H
ZK7HPS
EQ7HPS
60([
8
9
:
Figure 8-30 Connection overview with SME12x
SME12x
Direct measuring systems outside the cabinet can be connected to the Sensor Module
External 12x (SME12x). The SME12x evaluates these measuring systems and converts the
calculated values to DRIVE-CLiQ.
For more information about the SME12x, see the Equipment Manual "SINAMICS S120
For more information about the SME12x, see the Equipment Manual "SINAMICS S120
Control Units and Additional System Components", which can be obtained from your local
Siemens office.
1FW6 Built-in torque motors
144
Configuration Manual, 05/2009, 6SN1197-0AE00-0BP3