Samsung WM-202 Benutzerhandbuch

Set up UPnP access on a Windows PC - cont.

You will now need to connect your Internet radio to Windows Media Player 11
and conﬁ gure it to allow access to your media library.

3. Press

the

On/Off button to switch the radio on. Then press the Mode

button as needed until the 'Music Player' mode display is shown..
Press the Menu button to enter the main Music Player menu.

4. Rotate the Tuning/Select control until 'Shared media' is highlighted

and press the control to select. The radio will scan for all available
UPnP servers. It may take a few seconds for the radio to complete its
scan. The radio will display '<Empty>' if no UPnP servers are found.

5. After scanning, select your UPnP server using the Tuning/Select

control. If you are using WMP 11 as the server, your radio will then
normally display 'Unauthorised - Select to retry' at this stage.

6. Your PC may prompt you that there has been a connection to your

UPnP server. Whether prompted or not, to allow the radio to access
the media ﬁ les, you will need to click the 'Library' tab in WMP 11 and
select the 'Media Sharing…' item to open the 'Media Sharing' window.
Make sure the box 'Share my media to:' is ticked.

7. In the 'Media Sharing' window, the radio will be listed as an unknown

device. Click on the unknown device shown to select it, then click the
'Allow' button and then click 'OK'.

Note: If you are using Microsoft Windows' ﬁ rewall software, this should
be correctly conﬁ gured by WMP 11. If you are using third party ﬁ rewall
software you may need to manually conﬁ gure it to allow your radio
and WMP 11 to communicate (see 'Troubleshooting' on page 69).

8. On the radio, select the named server again using the Tuning/Select

control. If WMP 11 is now able to communicate with your radio you
will be presented with some media selection options on the display.

Allowing a device to connect to Windows Media Player 11

4,5,8