Toshiba Magnia Z300 Benutzerhandbuch

178

6 Install the Service and Software (Power Console Plus) of the 

RAID Controller (when the RAID Controller is additionally 
connected) or MegaRAID Configuration Console (when IDE 
RAID is used). 

7 Install the Backplane Driver (when IDE RAID is used). 

Use the floppy disk supplied with the RAID Controller for 
installation. 
See “MegaRAID Software Guide” for details of installation.

If the Toshiba Server Setup Tool is used, it automatically carries 
out setup of the system configuration and RAID (disk array) as 
well as installation of the MS-DOS. In other words, the Toshiba 
Server Setup Tool automatically prepares the installing environ-
ment for the NetWare.

On the other hand, an MS-DOS disk can be created by use of the 
Toshiba Server Setup Tool so that the MS-DOS environment can 
be set up manually without use of the DOS Installer of the Toshiba 
Server Setup Tool.

Activate the BIOS Setup Utility and select “Other” for “Installed 
O/S” appearing in the lower part of the “Advanced” menu.

To install NetWare, you need to first copy each driver to a floppy 
disk, using the Toshiba Server Setup Tool.

Start the Toshiba Server Setup Tool, select “Utilities” and “Create 
Floppy Disks,” and copy the following drivers to floppy disks:

DOS Disk

Adaptec Ultra160 NetWare Driver