New Buck Corporation 42 Benutzerhandbuch

1.  

If  the pilot cannot be lit with the piezo, it can be manually lit with the use of a paper 
match and a lighter rod. 

2.          Open access panel door located at bottom front of the appliance. 
3. 

Place the match in the holder and light.  With the left hand, turn the control knob 
counterclockwise 

 

to “PILOT”position. Press in gas control knob for fifteen 

(15) seconds.  

4.          Use rod to light match and ignite pilot. The pilot is located in front of the rear log and 
             burner on the right hand side of the appliance. 
5.          Continue to hold the control knob for an additional one (1) minute to ensure the pilot is  
              lit.                                     
6.          Turn control knob counterclockwise                       to the “ON” position.  Push the 
              “ON/   OFF” toggle switch to the “ON” position.  The main burner should light. 
7.          Close access panel door. 
8.          Turn on all electrical power to the appliance. 
NOTE:  This unit may be used with an optional Wall Thermostat.  If so, the Wall Thermostat 
needs to be set at a higher temperature than the room temperature. 

Page 33