Lantronix Computer Hardware 900-581 Benutzerhandbuch

This chapter describes accessing the PremierWave EN by using Telnet, SSH, or serial ports to 
configure the PremierWave EN, navigating the Command Line Interface (CLI), typing keyboard 
shortcuts, and moving between the levels. 

It contains the following sections:











Refer to 

 for a complete list of levels, commands, and 

descriptions.

To access and configure the device server by using a Telnet session over the network, you must 
first establish a Telnet connection. You can also establish a Telnet connection by clicking the 
Telnet Configuration tab in DeviceInstaller. See the DeviceInstaller Online Help for more 
information, available on our website 

www.lantronix.com/support/downloads

.

To access the PremierWave EN by using Telnet, perform the following steps.

1.

Click Start > Run. The Run dialog box displays.

2.

Type cmd in the dialog box and press OK.

3.

Type telnet x.x.x.x (x.x.x.x is the IP address). The PremierWave EN is online when the 
command prompt (>) displays.  You are at the root level of the CLI.

The serial port can be configured to operate in command mode permanently or to be triggered 
under specified conditions. See the line <line> Level command description for more 
information.

See the PremierWave EN User Guide for directions on connecting the USB port prior to 
configuration.

Serial Recovery mode will temporarily override the line and tunnel settings for the serial line to 
allow configuration changes to be made. The line and tunnel settings will be restored once the 
user exits the Serial Recovery mode CLI.