Hotbrick VPN 800 / 2 Benutzerhandbuch

HotBrick Network Solutions 

VPN Tunnel List– It shows the tunnels that you have entered. The 
router can setup up to 20 tunnels 

Tunnel Name– In order to distinguish the tunnel, you have to give 
“Tunnel” a name.. 

Tunnel – Only enable tunnel check box, the tunnel can be connected. 

WAN port – You can choose WAN1, WAN2 or Any to make the VPN 
connection. 

PPPoE Session– If you are using PPPoE to make the connection, and 
some ISP offers multiple PPPoE session, you can select these PPPoE 
session to construct VPN tunnels. 

Local Identity Type – You can either choose your Local WAN IP or 
Domain name, Distinguished Name as your local identity. 

Service– Protocol Type: You can choose either TCP/UDP/ICMP/GRE 
protocol as your connection protocol. By default the protocol type is 
“Any”. 

Local Security Network– These entries identify the private network on 
this VPN router, the hosts of which can use the LAN-to-LAN 
connection. You can choose a single IP address, the subnet, or a 
selected IP range to make VPN LAN-to-LAN connection. 

Remote Security Network– These entries identify the private network 
on the remote peer VPN router whose hosts can use the LAN-to-LAN 
connection. You can choose a single IP address, the subnet, or a 
selected IP range to make VPN connection 

Remote Security Gateway – You can either select remote side 
domain name or remote side IP address (WAN IP address) as your 
remote side security gateway. 

Encryption Method – It specifies the encryption mechanism to use. 

Data encryption makes the data unreadable if intercepted. There are 
three encryption method available; DES/3DES and AES. The default 
is null.  

Authentication – It specifies the packets authentication mechanism to 
use. Packets authentication proves that data comes from source you 
think it comes from. There are three authentications available. MD5, 
SHA1 and SHA2.  

Page 54