Hitachi Chainsaw CS 33EB Benutzerhandbuch

1.  Remove chain bar clamp nuts (1).

2.  Remove the side case (2) as pinching the rear 

part of the side case (2). (Fig. 1) 

2

1

Fig. 1

  *  In case of installing the spiked bumper (3), 

install the spiked bumper (3) (if so equipped) to 

the unit with two screws. (Fig. 2) 

3

Fig. 2

3.  Install the chain bar (4) onto the bolts (5), then 

push it toward the sprocket (6) as far as it will go. 

Make sure that the boss of chain tension adjust 

bolt (7) fi ts into the hole of the bar (8). (Fig. 3)

6

4

5

8

7

Fig. 3

  Slightly move the bar back and forth and make 

sure the chain tension boss (7) fi ts into the hole 

(8) in the bar properly. (Fig. 3)

4. Confi rm the direction of saw chain (9) is correct 

as in the fi gure, and align the chain on the 

sprocket. (Fig. 4)

9

Fig. 4

5.  Guide the chain drive links into the bar groove all 

around the bar.

6.  Install the side case (2) onto the bolts (5).

  Then tighten the clamp nuts (1) temporarily. 

(Fig. 1)

7. Raise the bar end, and tighten the chain (9) 

by turning the tension adjustment bolt (10) 

clockwise. To check proper tension, lightly lift 

up the center of chain and there should be about 

0.02 – 0.04 ″ (0.5 – 1.0 mm) clearance between 

bar and edge of drive link (11). (Fig. 5, 6)

9

11

10

0.02 – 0.04 ″

(0.5 – 1 mm)

Fig. 5

Fig. 6

8

000Book_CS33EB_US.indb   8

000Book_CS33EB_US.indb   8

2009/09/04   10:24:49

2009/09/04   10:24:49