Bolens LT1024 Servicehandbuch
13
Figure 5
•
If the gauge wheels have excessive clearance with
the surface below, lower the wheels to the index
hole that provides the approximate 1/2" clearance
as described above.
the surface below, lower the wheels to the index
hole that provides the approximate 1/2" clearance
as described above.
Refer to Leveling the Deck on page 16 of this manual for
more detailed instructions regarding various deck
adjustments.
more detailed instructions regarding various deck
adjustments.
Starting the Engine
WARNING:
Do not operate the tractor if the
interlock system is malfunctioning. This
system was designed for your safety and
protection.
system was designed for your safety and
protection.
NOTE:
Refer to the TRACTOR SET-UP on page 8 of this
manual for Gasoline and Oil fill-up instructions.
•
Insert the tractor key into the ignition switch.
•
Place the PTO/Blade Engage knob in the
disengaged (OFF) position.
disengaged (OFF) position.
•
Engage the tractor’s parking brake.
•
Place the throttle control in the FAST position
•
Pull the choke control outward.
•
Turn the ignition key clockwise to the START
position. After the engine starts, release the key. It
will return to the ON position.
position. After the engine starts, release the key. It
will return to the ON position.
IMPORTANT:
Do NOT hold the key in the START
position for longer than ten seconds at a time. Doing so
may cause damage to your engine’s electric starter.
may cause damage to your engine’s electric starter.
•
After the engine starts, deactivate the choke
control.
control.
NOTE:
Do NOT leave the choke control on while
operating the tractor. Doing so will result in a "rich" fuel
mixture and cause the engine to run poorly.
mixture and cause the engine to run poorly.
Stopping the Engine
WARNING:
If you strike a foreign object,
stop the engine, disconnect the spark plug
wire(s) and ground against the engine.
Thoroughly inspect the machine for any
damage. Repair the damage before restarting
and operating
wire(s) and ground against the engine.
Thoroughly inspect the machine for any
damage. Repair the damage before restarting
and operating
•
If the blades are engaged, place the PTO/Blade
Engage knob in the disengaged (OFF) position.
Engage knob in the disengaged (OFF) position.
•
Place the throttle control near the FAST position
•
Turn the ignition key counterclockwise to the STOP
position.
position.
•
Remove the key from the ignition switch to prevent
unintended starting.
unintended starting.
Engaging the Parking Brake
To engage the parking brake:
•
Fully depress the brake pedal and hold it there
while gently pushing the parking brake lever
downward.
while gently pushing the parking brake lever
downward.
•
Hold the parking brake lever down while removing
your foot from the brake pedal.
your foot from the brake pedal.
•
Once engaged, the parking brake lever and the
brake pedal will lock in the “down” position.
brake pedal will lock in the “down” position.
To disengage the parking brake:
•
Slightly depress the brake pedal.
NOTE:
The parking brake must be engaged if the
operator leaves the seat with the engine running or the
engine will automatically shut off.
engine will automatically shut off.
Driving The Tractor
WARNING:
Avoid sudden starts, ex-
cessive speed and sudden stops.
WARNING:
Do not leave the seat of the
tractor without first placing the PTO/Blade
Engage knob in the disengaged (OFF)
position, depressing the brake pedal and
engaging the parking brake. If leaving the
tractor unattended, also turn the ignition key
off and remove the key.
Engage knob in the disengaged (OFF)
position, depressing the brake pedal and
engaging the parking brake. If leaving the
tractor unattended, also turn the ignition key
off and remove the key.
•
Briefly depress the brake pedal to release the
parking brake. Move the throttle lever into the FAST
(rabbit) position.
parking brake. Move the throttle lever into the FAST
(rabbit) position.
IMPORTANT:
Do NOT attempt to change the direction of
travel when the tractor is in motion. Always bring the
tractor to a complete stop before pivoting the drive
pedal from forward to reverse or vice versa.
tractor to a complete stop before pivoting the drive
pedal from forward to reverse or vice versa.
Shoulder Screw
Lock Nut
Lock Nut
Shoulder Screw