Bolens 18M Servicehandbuch

Seite von 48
16
10
Maintaining 
Your
Engine
WARNING
Shut off the engine
before performing
any maintenance. To
prevent accidental
start-up, disconnect
the spark plug boot.
Figure 10-1
Tasks
First 5 Hrs.
Each Use or 
Every 5 Hrs.
Every Season 
or 25 Hrs.
Every Season 
or 50 Hrs.
Every Season 
or 100 Hrs.
Service
Dates
Check Engine 
Oil
Change 
Engine Oil
             ††
Check Air 
Cleaner
Service Air 
Cleaner
            †
Check Spark 
Plug
Service Spark 
Plug
Clean Finger 
Guard
Clean Around 
Muffler
WARNING: Shut off the engine before
performing any maintenance. To
prevent accidental start-up, disconnect
the spark plug boot.
IMPORTANT: If engine must be tipped to transport 
equipment or to inspect or remove grass, keep spark 
plug side of engine up. Transporting or tipping engine 
spark plug down may cause smoking, hard starting, 
spark plug fouling, or oil saturation of air cleaner.
Periodic inspection and adjustment of the engine is 
essential if high level performance is to be maintained. 
Regular maintenance will also ensure a long service life. 
The required service intervals and the kind of mainte-
nance to be performed are described in the table below. 
Follow the hourly or calendar intervals, whichever occur 
first. More frequent service is required when operating in 
adverse conditions.
Maintenance Schedule
† Service more frequently when used in dusty areas.
††  If operating under heavy load or high ambient temperature.
Oil Service
•  Check oil level regularly.
•  Be sure correct oil level is maintained. Check every 
5 hours or daily before starting engine. See oil 
checking procedure on page 16.
Oil Change
IMPORTANT: Be sure to check engine on a level surface 
with the engine stopped. Drain the oil while the engine is 
still warm to assure rapid and complete draining.
1.  Remove oil fill cap and drain oil by either removing 
drain plug or turning mower on its side (air cleaner side 
up) and allowing oil to drain into a suitable container. 
See Figure 10-1.
WARNING: Before tipping engine or
equipment to drain oil, drain fuel from
tank by running engine until fuel tank is
empty.
2.  Reinstall the drain plug (if removed), and tighten it 
securely.
3.  Refill with the recommended oil (see page 16) and 
check the oil level. See Figure 10-1.
4.  Reinstall the oil fill cap securely.
Before tipping engine
or equipment to
drain oil, drain fuel
from tank by running
engine until fuel tank
is empty.
IMPORTANT
Be sure to check 
engine on a level 
surface with the engine 
stopped. Drain the oil 
while the engine is still 
warm to assure rapid 
and complete draining.
Oil Fill Cap
Drain
Plug
Level