White Outdoor 500 Benutzerhandbuch

1.  Lubricate pivot points on the blade control at least once 

a season with light oil. The blade control must operate 
freely in both directions. See Figure 3.

2.  Lubricate the wheels at least once a season with 

light oil (or motor oil). If  wheels are removed for any 
reason, lubricate surface of the axle bolt and inner 
surface of the wheel with light oil. See Figure 3.

3.  Lubricate the torsion spring and pivot point on the 

chute deflector periodically with light oil to prevent rust. 
See Figure 3. 

4.  Follow the accompanying engine manual for lubrication 

schedule and instruction for engine lubrication.

1.  Change the engine oil regularly, as instructed in the 

engine manual. Check oil level before starting engine 
every time.

2.  Service air cleaner every 25 hours under normal condi-

tions. To service the air cleaner, refer to the separate 
engine manual packed with your unit.

3.  Clean the spark plug and reset the gap to.030” at least 

once a season. Refer to the engine manual for correct 
spark plug type. Refer to Figure 4.

Clean underside of the mower deck after each use to 
prevent build-up of grass clippings or other debris. Follow 
steps below for this job.
1.  Disconnect spark plug wire. Drain gasoline from lawn 

mower, or place a piece of plastic under the gas cap 
See Figure 4.

2.  Tip the mower so that it rests on the housing. Keep 

the side with the air cleaner facing up. Hold the mower 
firmly.

3.  Scrape and clean the underside of the deck with a 

suitable tool. Do not spray with water. 

4.  Put the mower back on its wheels on the ground. If you 

had put plastic under the gas cap earlier, make sure to 
remove it now.

We do not recommend 
the use of pressure 
washers or garden 
hose to clean your 
unit. These may cause 
damage bearings, or 
the engine. The use 
of water will result in 
shortened life and 
reduce serviceability.

1.  Always observe safety rules when performing  

any maintenance.

2.  The warranty on this lawn mower does not cover 

items that have been subjected to operator abuse 
or negligence. To receive full value from warranty, 
operator must maintain the lawn mower as  
instructed here. 

3.  Changing of engine-governed speed will void  

engine warranty. 

4.  All adjustments should be checked at least once 

each season. 

5.  Periodically check all fasteners and make sure these 

are tight.

����������

�������������

�������

�����������

����������

�������

�������

����������

����