High End Systems High End LCD Controller for Studio Color Benutzerhandbuch

Studio Color LCD Controller

Using the Construct Keys

3-17

3

Lens 2 has the following effects:

•

Beam shaping:  A long, narrow beam rotates into a 
short, fat beam.  Construct values between approximately 
100 (39%) and 220 (86%) select beam shaping.  (Values 
above about 220 or 86% move toward the open position.)

•

Frost:   The “effect” position is frost—soft, undefined 
beam edges.  Values between below approximately 100 
(39%) select frost.

The transition time of this construct is set using the 
XFade construct as described in the section titled 
“Xfade Key” on page 3-14.

Allows you to select color mixing options:  normal or double.

Normal color mixing means the values of the Red, Green or 
Blue constructs (0—255) correspond directly to the resulting 
color.  Use this choice to achieve gradual color changes with 
the full spectrum of available colors.

Double color mixing is useful to achieve faster (or snap) 
color changes but limits your available colors.  Values of 0—
255 for Red, Green or Blue constructs give you two full 
cycles (from 0% color to 100%) of the selected color.  A  
value of 0 is zero intensity for the color; a value of about 122 
(48%) is full intensity, a value of about 140 (55%) is zero 
intensity and a value of 255 is full intensity.

Follow the procedure below to see how this works:

1.

Use the Page

<Up> 

and 

<Down> 

arrow keys to select a page 

that has not been programmed yet.

2.

Toggle the 

<Standby>

 key until the Standby LED turns OFF.

3.

Press the 

<Select>

 key and then press the Address keys 

corresponding to one or more fixtures.