Maxon Telecom Modem MM-6280IND Benutzerhandbuch

 

 

HSDPA Standard At Commands        Page 15 of 60                             Version 1.2 

 

 

+CMEE 

   

Report Mobile Termination error  

supported 

Set command disables or enables the use of result code +CME ERROR: <err> as an 
indication of an error relating to the functionality of the MT. When enabled, MT related 
errors cause +CME ERROR: <err> final result code instead of the regular ERROR final result 
code. ERROR is returned normally when error is related to syntax, invalid parameters, or TA 
functionality. 

+CMEE=[<n>]  

+CMEE? +CMEE: 

<n> 

+CMEE=? 

+CMEE: (list of supported <n>s) 

value 

<n>: 

0  disable +CME ERROR: <err> result code and use ERROR instead 

1  enable +CME ERROR: <err> result code and use numeric <err> values (refer 

next subclause) 

2  enable +CME ERROR: <err> result code and use verbose <err> values (refer 

next subclause) 

The operation of +CME ERROR: <err> result code is similar to the regular ERROR result code: if 

+CME ERROR: <err> is the result code for any of the commands in a command line, none of the 

following commands in the same command line is executed (neither ERROR nor OK result code shall 

be returned as a result of a completed command line execution). The format of <err> can be either 

numeric or verbose. This is set with command +CMEE (refer previous subclause). 

<err> values (numeric format followed by verbose format): 

0 phone 

failure 

1  no connection to phone 

2 phone-adaptor 

link 

reserved 

3 operation 

not 

allowed 

4 operation 

not 

supported 

5  PH-SIM PIN required 

6  PH-FSIM PIN required