Maxon Telecom Modem MM-6280IND Benutzerhandbuch

Seite von 60
 
 
HSDPA Standard At Commands        Page 25 of 60                             Version 1.2 
 
 
Table 15. 
+CREG parameter command syntax
 
Command 
Possible response(s) 
+CREG=[<n>]  
+CREG? +CREG: 
<n>,<stat>[,<lac>,<ci>] 
+CME ERROR: <err> 
+CREG=? +CREG: 
(
list of supported <n>s) 
value 
<n>
0  disable network registration unsolicited result code 
1  enable network registration unsolicited result code +CREG: <stat> 
2  enable network registration and location information unsolicited result code +CREG: 
<stat>[,<lac>,<ci>]
 
<stat>
0  not registered, MT is not currently searching a new operator to register to 
1  registered, home network 
2  not registered, but MT is currently searching a new operator to register to 
3 registration 
denied 
4 unknown 
5 registered, 
roaming 
<lac>
: string type; two byte location area code in hexadecimal format (e.g. "00C3" 
equals 195 in decimal) 
<ci>
: string type; two byte cell ID in hexadecimal format 
 
1.20.  PLMN selection +COPS 
Set command forces an attempt to select and register the GSM/UMTS network operator. <mode> 
is used to select whether the selection is done automatically by the MT or  is  forced  by  this 
command to operator <oper>  (it shall be given in format <format>) to a certain access 
technology, indicated in <AcT>. If the selected operator is not available, no other operator shall 
be selected (except <mode>=4). If the selected access technology is not available, then the same 
operator shall be selected in other access technology. The selected operator name format shall 
apply to further read commands (+COPS?) also. <mode>=2 forces an attempt to deregister from 
the network. The selected mode affects to all further network registration (e.g. after <mode>=2, 
MT shall be unregistered until <mode>=0 or 1 is selected). 
This command should be abortable when registration/deregistration attempt is made. 
Read command returns the current mode, the currently selected operator and the current Access 
Technology. If no operator is selected, <format>, <oper> and < AcT>  are omitted.