Maxon Telecom Modem MM-6280IND Benutzerhandbuch

 

 

HSDPA Standard At Commands        Page 43 of 60                             Version 1.2 

 

 

parameters on the form 'f.t'. 

<source port range>

:Consists of dot-separated numeric (0-65535) parameters on the 

form 'f.t'. 

<ipsec security parameter index (spi)>

: Hexadecimal parameter,  

value range from 00000000 to FFFFFFFF. 

<type of service (tos) (ipv4) and mask / traffic class (ipv6) 

and mask>

:  

Dot-separated numeric (0-255) parameters on the form 't.m'. 

<flow label (ipv6)>

: Hexadecimal parameter, value range from 00000 to FFFFF. 

Valid for IPv6 only. 

<evaluation precedence index>

: Numeric parameter, value range from 0 to 255.

Some of the above listed attributes may coexist in a Packet Filter while others mutually exclude 
each other, the possible combinations are shown in 3GPP TS 23.060[47]. 

 

This command allows the TE to specify a Quality of Service Profile that is used when the MT 
sends an Activate PDP Context Request message to the network. 

The set command specifies a profile for the context identified by the (local) context identification 
parameter,  <cid>. Since this is the same parameter that is used in the +CGDCONT and 
+CGDSCONT commands, the +CGQREQ command is effectively an extension to these 
commands. The QoS profile consists of a number of parameters, each of which may be set to a 
separate value. 
A special form of the set command, +CGQREQ= <cid> causes the requested profile for context 
number <cid> to become undefined. 

The read command returns the current settings for each defined context. 

The test command returns values supported as a compound value. If the MT supports several 
PDP types, the parameter value ranges for each PDP type are returned on a separate line.  

+CGQREQ=[<cid> 

[,<precedence> 

[,<delay> 

[,<reliability.> 

[,<peak> 

[,<mean>]]]]]] 

OK 
ERROR 

+CGQREQ? 

+CGQREQ:<cid>,<precedence>,<delay>,<reliability>, 

 <peak>,<mean> 

[<CR><LF>+CGQREQ:<cid>,<precedence>,<delay>, 
<reliability.>,<peak>,<mean>[…]]