Dacor RNRP48G Benutzung Und Pflege

20

Oven Racks

To prevent damage, do not leave the oven racks inside 

the oven during the self clean cycle.

The oven racks are chrome-plated. Clean with a 

solution of detergent and hot water. To clean heavy 

soil, use the rough side of a sponge or a scouring 

pad with plenty of water, or use a solution of 1 cup 

ammonia to 2 gallons of water. 

Convection Filter (Oven)

•  The convection filters are made of stainless steel. 

Remove them only when the oven is cool.  

•  Re-install the filter in the oven before using it again. 

Failure to do so will expose the convection fan blade 

that rotates at high speed during convection modes.

•  Remove the filter regularly for cleaning. A 

clogged filter will reduce the effectiveness of 

convection cooking. Soak it in hot soapy water. 

Dry it completely before re-installing. 

•  To reinstall, orient the filter so that the mounting 

clips are towards the rear of the oven, open end 

down. Hook the mounting clips over the top of 

the horizontal edge across the opening.

5

Care and Cleaning

Replacing the Oven Light

•  To prevent an electrical shock hazard and/or personal 

injury, make sure that power to the range has been 

disconnected and that the light fixture is cool before 

replacing the light bulb.

•  Always ensure that the lens cover is in place when 

using the oven. The lens cover protects the bulb 

from breakage caused by high oven temperatures or 

mechanical shock.

•  Replacing the lens cover without lining up the cutout 

with the light socket will damage the light fixture.

•  Do not use a screwdriver to remove the lens.

Replacing a Light Bulb

Light bulb replacement is considered a homeowner 

maintenance operation. If the light does not work, 

before replacing it, please consult the Problem 

Solution Guide on page 21.
1.  Replace the light bulb only with Dacor part 

number 108774. See page 23 for ordering 

information. IMPORTANT: Do not touch the 

replacement halogen light bulb with your fingers. 

Halogen bulbs are sensitive to the oils from your 

hand. The oils from your hand will stick to the 

bulb and may cause it to burn out faster than 

normal.

2.  Disconnect the power cord from the electrical 

outlet.

3.  Remove the rack support in front of the light.
4.  Hold your hand under the lens for support and 

gently pry it loose using a spatula or table knife. 

Pull the lens 

cover straight 

out.

5.  Grasp the old 

bulb and pull it 

straight out of 

the socket.

6.  Using a glove, 

insert the new 

bulb into the 

socket.

7.  As you reinstall 

the lens cover, 

line up the 

cutout on the 

inside rim with the light socket. Gently press it 

into its original position.

8.  Replace the rack support and reconnect the 

power cord.

Clips on back 

of filter

Horizontal 

edge

Light 

fixture

Light  

socket

Lens

Lens cutout

Bulb