Elica EMD536S2 Installationsanweisungen

Seite von 52
 
16 
 
Maintenance 
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the 
connector and removing the connector fuse.  
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. 
 
Cleaning 
Do not spray cleaners directly to the control while 
cleaning the Hood.
The cooker hood should be cleaned 
regularly (at least with the same frequency with which you 
carry out maintenance of the fat filters) internally and 
externally.  Clean using the cloth dampened with neutral 
liquid detergent. Do not use abrasive products. DO NOT 
USE ALCOHOL!
 
WARNING:  
Failure to carry out the basic cleaning recommendations of 
the cooker hood and replacement of the filters may cause 
fire risks.  
Therefore, we recommend oserving these instructions. 
The manufacturer declines all responsibility for any damage 
to the motor or any fire damage linked to inappropriate 
maintenance or failure to observe the above safety 
recommendations. 
 
Grease Filter 
Traps cooking grease particles.  
This must be cleaned once a month using non aggressive 
detergents, either by hand or in the dishwasher, which must 
be set to a low temperature and a short cycle.  When 
washed in a dishwasher, the grease filter may discolour 
slightly, but this does not affect its filtering capacity. 
To remove the grease filter, pull the spring release handle. 
 
 
 
Replacing the light bulb 
CAUTION 
Before replacing the lamps, switch power off at service 
panel and lock service panel disconnecting means to 
prevent power from being switched on accidentally. 
 
NOTE: Turn off the lights and fan.  Allow the lights to  
cool before handling.
    If new lights do not operate be 
sure lights are inserted correctly before calling service. 
  
  
 
  
Replace Lights  
•  Remove the damaged light (twist  counter clockwise) 
and replace with a new 120 Volt, 50 Watt (maximum) 
50° halogen light made for a GU10 base, suitable for 
use in open luminarie
 
Charcoal Filter 
If the model is not vented to the outside, the air will be 
recirculated through disposable charcoal filters that help 
remove smoke and odors. 
The charcoal filters cannot be cleaned. 
They must be replaced. 
Cover the grill that protects the suction motor with the 
carbon filter so that the slots on the filter correspond to the 
pins on the sides of the motor protection grill. 
Turn the carbon filter clockwise to block them (bayonet 
fixing). 
The charcoal filters should be replaced every 4-6 months 
(depending on hood usage). 
NOTE: DO NOT rinse, or put charcoal filters in an automatic 
dishwasher. 
NOTE: Charcoal filters are not included with the hood.  
They must be ordered from your supplier. 
Order the needed kit specifying your hood model and width 
size.