Psion Teklogix 8570 Benutzerhandbuch

Seite von 124
Teklogix 8570 Vehicle-Mount Computer User Manual
73
Chapter 6: Troubleshooting
Introduction
6.1  Introduction
This chapter provides information on the recognition and correction of problems 
that you may encounter when operating the 8570 Vehicle-Mount Computer. 
If problems are encountered that are not identified here or that can’t be resolved, 
please refer to Appendix A: “Support Services And Worldwide Offices”  for 
contact information.
6.2  Preventive Measures
Check that the computer is connected to a working power source.
Make sure that the computer is on. Touch the screen to take the computer 
out of Suspend.
To ensure that no data are lost, always exit from Windows before turning 
the computer power off.
A Microsoft Windows licensed registration number is affixed under the port 
cover of each 8570 unit. The My-T-Soft license information is printed on a 
paper tag that is shipped with each unit. This information is required to rein-
stall the 8570 operating system and My-T-Soft.
IT IS CRITICAL that you write down the Microsoft Windows registration 
number and then store it and the My-T-Soft registration tag in a safe place 
alongside the computer’s backup information.
Backup the directory D:\Install in its entiretyincluding the drivers direc-
tory, the Win98 or i386 directory and the DOS utilities. In case of hard drive 
corruption, these files are required to restart your computer. For additional 
information, see “D: Install Partition” on page 76 and “Software Load-
ing/Installation Procedure” on page 77.
Create a bootable system disk.
Turn up the brightness control if the display is dim or off.
Make sure that the display backlight is set correctly for your needs in 
the BIOS.
Check all cable connections for loose or incorrect installation.
Take out any PCMCIA cards before booting the computer.
In the unlikely event that an error is detected during the Power-On-Self-Test 
(POST) after the computer is turned on, the system will display the BIOS 
Setup entry or a “resume boot” prompt, or will continue to try to boot.