Patton electronic 1001MC Benutzerhandbuch

Model 2701 Configuration page MIB variables description

Model 1001MC Operations Guide 

This displays if the 2701RC is using the DIP switch control or software control for its configuration.

If the 2701RC is operating in G.704 channelized mode, a configurable 

Channel Assignment

 table appears. 

When line format is set to frame-G704(1), individual channels can be either enabled(1) or disabled(0). These 
options cannot be accessed if line format is set to frame-G703(0). 

Timeslot 0 (Channel 1) is reserved for synchronization when G.704 
is enabled therefore, this channel cannot be accessed. Also, if CAS 
multiframing is enabled, Channel 16 cannot be accessed because it is 
used for signaling with CAS is enabled.

This table shows the configurable MIB variables for the set of units. After changes are made, select the 

 button at the bottom of the table and then place the Input Mode back to onLine(0) in the Model 2701 

Configuration page. 

The following sections explain the MIB variables that are shown in the Unit Configuration table.

This option is used to set the line format to the following:

•

frame-G703(0)—G.703 unframed

•

frame-G704(1)—framed G.704

This variable defines the clock mode for the NetLink-E1 modems. The following options are available:

•

network-CLK(0)

•

internal-CLK(1)

•

external-CLK(2). 

This read-only variable displays the DTE rate for the link. This is the Nx64 kbps data rate selected by the 
number of activated channels.

This variable is used to select the G.703 line coding. The following options are available:

•

code-HDB3(0)—HDB3

•

code-AMI(1)—AMI