Sony CDX-GT410U Handbuch

Tone controls:

Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)

Power requirements: 12 V DC car battery

(negative ground (earth))

Dimensions: Approx. 178

× 50 × 179 mm

× 2 × 7

in) (w/h/d)

Mounting dimensions: Approx. 182

× 53 × 162 mm

× 2

× 6

in) (w/h/d)

Mass: Approx. 1.2 kg (2 lb 11 oz)
Supplied accessories:

USB cap
Card remote commander: RM-X151
Parts for installation and connections (1 set)

Optional accessories/equipment:

BUS cable (supplied with an RCA pin cord):
RC-61 (1 m), RC-62 (2 m)
CD changer (10 discs): CDX-757MX
CD changer (6 discs): CDX-T69
Source selector: XA-C40
AUX-IN selector: XA-300
Interface adaptor for iPod: XA-110IP

Your dealer may not handle some of the above listed
accessories. Please ask the dealer for detailed
information.

Design and specifications are subject to change
without notice.

Troubleshooting

The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.

General

No power is being supplied to the unit.

• Check the connection. If everything is in order, check

the fuse.

• If the unit is turned off and the display disappears, it

cannot be operated with the remote commander.

t Turn on the unit.

US and foreign patents licensed from Dolby
Laboratories.

MPEG Layer-3 audio coding technology and
patents licensed from Fraunhofer IIS and Thomson.

• Halogenated flame retardants are not used in the

certain printed wiring boards.

• Halogenated flame retardants are not used in

cabinets.

• Cushions made from paper.
• VOC (Volatile Organic Compound)-free vegetable

oil based ink is used for printing the carton.
(CDX-GT41UW only)

The power antenna (aerial) does not extend.

The power antenna (aerial) does not have a relay box.

No sound.

• The volume is too low.
• The ATT function is activated.
• The position of the fader control “FAD” is not set for

a 2-speaker system.

• The CD changer is incompatible with the disc (MP3/

WMA/AAC/ATRAC CD).

t Play back with this unit.

No beep sound.

• The beep sound is canceled (page 11).
• An optional power amplifier is connected and you are

not using the built-in amplifier.

The contents of the memory have been erased.

• The RESET button has been pressed.

t Store again into the memory.

• The power supply lead or battery has been

disconnected.

• The power supply lead is not connected properly.

Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
is switched.

The leads are not matched correctly with the car’s
accessory power connector.

The display disappears from/does not appear
in the display window.

• The dimmer is set “DIM-ON” (page 11).
• The display disappears if you press and hold (OFF).

t Press and hold (OFF) on the unit until the

display appears.

• The connectors are dirty (page 15).

The Auto Off function does not operate.

The unit is turned on. The Auto Off function activates
after turning off the unit.
t Turn off the unit.

Card remote commander operation is not
possible.

Make sure the insulation film has been removed
(page 4).

CD/MD playback

The disc cannot be loaded.

• Another disc is already loaded.
• The disc has been forcibly inserted upside down or in

the wrong way.

The disc does not playback.

• Defective or dirty disc.
• The CD-Rs/CD-RWs are not for audio use (page 13).
• The disc format and file version are incompatible

with this unit (For details, refer to page 4 a nd 13).

MP3/WMA/AAC files cannot be played back.

The disc is incompatible with the MP3/WMA/AAC
format and version (page 14).

continue to next page