Samsung RS26WUNS Benutzerhandbuch

30

- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.

If any, repeat the connection.

- Reattach the compressor cover of the refrigerator.

- Using clip ”A”, fix the water line to the wall (the back of refrigerator).

- When the water line is secure, make sure whether the

water line is not excessively bent, pinched or squashed.

Complete the installation of the water supply line.

- Power on the refrigerator and press the lever on the right of the

dispenser until water runs out through the water line and all air has been empty.

- At this time, check for any possible leakages at the join point in the water line.

After securing the water line, move the refrigerator to the required location.

Once the refrigerator is in position, do not move possibly.

CLIP A

WATER LINE

WATER LINE

CONNECTION NUT

COMPRESSOR COVER OF
REFRIGERATOR

WARRANTY INFORMATION
This water line installation is not covered by the refrigerator
or ice maker manufacturer's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.

If the coupler does not fit on the current tap, go

the nearest authorised service dealer and purchase

the right couplers fittings.

Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler “A” to the tap.
- Every join should be protected with sealing tape.

COUPLER “A”

TAP

DA99-00810A-0.6(EN)  3/14/07 11:52 AM  Page 30